Qlogic SANsurfer FC HBA Manager Betriebsanweisung PDF herunterladen (Seite 157)

10 – Performing Diagnostics

Preparing for Diagnostic Testing

FS0054603-00 C 10-5

10.1.3

Preparing for the Read/Write Buffer Test

The read/write buffer test must be run on a device (disk or tape). Before running

the read/write buffer test, from the SANsurfer FC HBA Manager main window HBA

tree, verify that the HBA port is connected to at least one device.

NOTE: Some devices may not support Read/Write Buffer commands. Check with

your hardware vendor or manufacturer.

You can run the read/write test on all devices attached to the HBA port or to specific

devices attached to the HBA port.

To run the read/write test on all devices attached to an HBA port, perform the

following steps from the SANsurfer FC HBA Manager main window:

1. Right-click an HBA port in the HBA tree.

2. From the drop-down menu, select Device Diagnostics, then choose Enable

All Devices. A check mark displays next to all the device icons attached to the

selected HBA port.

To run the read/write test on specific devices attached to an HBA port, perform the

following steps from the SANsurfer FC HBA Manager main window:

1. Right-click a device in the HBA tree.

2. Select Device Diagnostics, then choose Enable on Device. A check mark

displays next to the device icon.

3. Repeat steps 1 and 2 for each device you want to test.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 217 218

Keine Kommentare

Qlogic SANsurfer FC HBA Manager Betriebsanweisung Seite 157