Qlogic SANsurfer FC HBA Manager Betriebsanweisung

SANsurfer FC/FCoE HBA ManagerQLogic Corporation. All rights reserved.Table of Contents1.Package Contents2.Requirements 2.1 Hardware Requirements 2.2 S

Workaround: Follow these steps:1. Temporarily uninstall SANsurfer FC HBA Manager.2. Install Microsoft Windows Services for UNIX.3. Re-install SANsu

up to a multiple of the system page size.) See limit(1) to increase the stack size limit.Workaround: None7.16 Mac OS X Bug on SANsurfer FC HBA Manager

1. Package Contents SANsurfer FC HBA Manager installation packages are available for the following supported operating system (OS) platforms (where “n

2.2 Software RequirementsSANsurfer FC HBA Manager requires the following minimum software:● Common desktop environment (CDE) to run the SANsurfer

4. Supported FeaturesSANsurfer FC HBA Manager provides a graphical user interface (GUI) that lets you easily install, configure, and deploy QLogic Fib

5.3 Removing SANsurfer FC HBA Manager You must exit the SANsurfer FC HBA Manager installer before you uninstall SANsurfer FC HBA Manager.To remove SAN

/etc/hosts● NetWare: Windows System’s NetWare client <install drive>: windows\system32\drivers\etc\hosts● VMware:/etc/hosts6.1.2 Enablin

To resolve this issue, create a new entry with the host IP address assigned to ethx. Modify the existing entry by moving the hostname from the localho

output control (IOCTL) module. After installing but before starting SANsurfer, execute the following command:# modprobe -a qioctlmodIf qlremote is not

6.7 VMware ESX 6.7.1 Operating SANsurfer FC HBA Manager on ESX 3.5 ServersFlashing/updating NVRAM has been disabled for QLE25xx adapters on ESX 3.5U2.