Qlogic iSR6142 Installationsanleitung PDF herunterladen (Seite 58)

4 – Installation

Firmware Installation

4-12 SN0051102-00 A

Using the CLI to Install Firmware

To use the CLI to install the firmware, transfer the firmware image file from a

workstation to the router. Then use the CLI image unpack command to install

the new firmware image:

1. At the workstation prompt, use the ftp command to go to the location on the

router where you want to transfer the firmware image. For example:

C:\fwImage>ftp 172.17.137.190

Connected to 172.17.137.190.

220 (none) FTP server (GNU inetutils 1.4.2) ready.

2. Enter your username and password. For example:

User (172.17.137.190:(none)) – ftp

331 Guest login ok, type your name as password.

Password – ftp

230 Guest login ok, access restrictions apply.

3. At the ftp prompt, type BIN to set binary mode. For example:

ftp> bin

200 Type set to I.

4. Use the put command to transfer the firmware image file from the

workstation to the router. For example:

ftp> put isr-6142-2_2_0_x.bin

200 PORT command successful.

150 Opening BINARY mode data connection for

'isr-6142-2_2_0_x.bin'.

226 Transfer complete.

ftp – 4822816 bytes sent in 0.41Seconds

11878.86Kbytes/sec.

5. Type quit. The firmware image has been transferred to the router.

6. Log on to the router as an administrator.

(none) login – guest

Password – password

******************************************************

* *

* QLogic Router Command Line Interface (QRCLI) *

* *

******************************************************

QRouter#> admin start

Password – config

QRouter (admin) #>

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 119 120

Keine Kommentare

Qlogic iSR6142 Installationsanleitung Seite 58